Before you start, follow the instruction in the link below to remove the seats and then the gas tank.

http://www.hondarebelforum.com/showthread.php?t=1425

__ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __

With the seats and tank removed you are ready to start the carb removal process.



First, if your bike has the chrome carb cover, you will need to remove it by removing the 2 phillips screw on the front of it. See below. (If not you may skip this step)



Next you will need to loosen the 10mm nuts on the idle and the throttle cables. See below.



Next remove the idle and throttle cable from the cable guide. See below.



Next you can lay the thrittle and idle cables along the fram to keep them out of the way. See below.



Next move around to the other side of the bike and remove the choke cable from the carb. See below.



Next loosen the phillips screw on the hose clamps on the front and rear of the carb. See below.



With these steps taken you can guide the carb out of the bike.

To reinstall the carb, reverse the steps.