[flitecontrol]

The rotor part number is identical for both generations, so they are the same. If no one here has a spare, check Ebay. 04 Honda Rebel 250 CMX250 CMX 250 Front Brake Rotor | eBay

 

[Emil]

Make sure you check the thickness before you buy it.. A new one is .40mm One that is no good is below .35mm

 

[86 rebelre]

Thanks for the tip I’ll make sure I look for that

 

[flitecontrol]

A rotor sourced from a low mileage bike is probably well within specs if you can't get a measurement. Ebay rotor linked above is from a bike with less than 8,000 miles.

 

[seattle_rider]

I'm also looking for a rotor for my '85. None of the used parts list a thickness, and while I don't mind asking, I bet they'll measure at the edge, not at the wear surface. Does anyone have a specific seller that you've had a good experience getting a straight answer from?

My bike has 12.5k miles on it and the rotor measures right at 3.5mm (0.135" to 0.140", which is 3.429mm to 3.556mm). Do I need to be looking for a part off a ~4k mile bike?

Thanks folks!

 

[SoakedKarma]

I'm also looking for a rotor for my '85. None of the used parts list a thickness, and while I don't mind asking, I bet they'll measure at the edge, not at the wear surface. Does anyone have a specific seller that you've had a good experience getting a straight answer from?

My bike has 12.5k miles on it and the rotor measures right at 3.5mm (0.135" to 0.140", which is 3.429mm to 3.556mm). Do I need to be looking for a part off a ~4k mile bike?

Thanks folks!

I'd ask seller to mic the thickness in center of wear area.. rely on what seller states, if what you get is 3.5mm or less return for refund,, NAD not as described..