Honda Rebel 250 & 450 Forum banner

how to clamp ( and where ) turn lights on a chopped rebel 1987

1K views 6 replies 3 participants last post by  Emil 
#1 ·
Hi there,
I purchased a chopped Honda rebel 1987 and I would like to restore some of the parts that were decommissioned by the previous owners.
One of the thing I would like to have are the turning lights. I have already purchased some cheap lights from amazon. I assume I need some clamps to connected them with the fork at the front. Any suggestion which clamp to buy? if you have better turning lights to suggest I can always return those to amazon.
Thanks
Luca
1987 Honda Rebel 250
 
#2 ·
Hard to advise as there are several different ways turn signal lights are designed to attach
some have hollow stem wiring runs through others have wires exiting out back side
Post a link to the ones you bought, it would be much easier for us to help you out..
 
#5 ·
Rebel has 33mm fork tubes

Imagine you have seen these, not my first choice

I like these except they are 1mm too small, likely will not fit

I like these too, will take some time to arrive,, never had a problem with Chinese orders..
 
#7 ·
I took some build up rubber tape & installed HD turn/markers on mine.
Only needed 2 wraps to get the desired results. Stays put.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top