Honda Rebel 250 & 450 Forum banner

Honda rebel 250 - seat removal

102K views 35 replies 23 participants last post by  Texon Stormy  
#1 ·
Here is a tutorial for the step to remove the seat on a honda rebel 250.

Here is what your seat looks like before you get started. See below.

Image


First remove the 2 8mm screws at the rear of the passenger seat on either side of the tail light. See below.

Image


Next slide the passenger seat away from the driver seat to release the clip holding the front edge of the passenger seat. See below

Image


Next remove the 2 12mm bolts holding the fram of the driver seat. See below.

Image


Now slide the driver seat away from the tank to release the clip holding the front edge of the seat. See below.

Image


You have successfully removed your seat. Just reverse the process to remount the seats.
 
#29 · (Edited)
Thanks again Big J,my brake light wasn't working so I checked the fuses I could find.Fuses were good.So checked bulb again and it was good,bought two new ones because I did not have extras.So now I'm thinking that it must be in the wiring.But where to look?Automatically I grabbed my tablet to go to the HRF for the answer,and saw your tutorial on removing the seats,followed the instructions and bingo the seats were off!First thing I saw was a clip not connected,put it back in place and brake light works!Wow I fixed something on my Rebel,you folks Rock!Thank you for sharing your advice and knowledge I couldn't have done it without it!!!