Honda Rebel 250 & 450 Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Wrenching - General Discussions & Tech Talk
    Bike starts good but when starting it will sometimes make a very loud honking noise, did some reading and think it might be something to do with the starter clutch, what should I do next - 86 cmx250
  2. Wrenching - General Discussions & Tech Talk
    i am currently replacing starter clutch now and upon reinstalling new starter clutch i noticed the driven gear once i slid it onto the shaft it goes inside the clutch housing but still spins freely no mater which direction i spin it fast or slow. so i paused on starter clutch for now till i hear...
  3. Engine, Carburetor, Fuel System & Exhaust
    After reinstalling my flywheel after replacing oil seal, the starter is not cranking engine. I'm not sure if I tightened the flywheel bolt too much or not enough? Has anyone had a starting issue after incorrectly installing the flywheel? I plan on pulling off left side cover today, but I thought...
  4. Electrical, Charging and Battery
    The starter mostly spins, but occasionally catches and starts the engine. Any suggestions? and is there a way/place to refer to that gives how to instructions on maintenance/repairs?
  5. Gears, Sprockets & Chains
    Hi, everybody! Thanks in advance for responses. I have a 1986 Rebel CMX250. I need to replace the starter clutch, and I want to do it myself. My manual (Clymer) does not seem to have anything on the starter clutch. But I can't find any good diagrams or instructions on how to do this. I've...
  6. Wrenching - General Discussions & Tech Talk
    i want to start with thanks.:Thanx: through all of the awesome help i've been getting on this forum, i determined that the intermittent starting problem with my reb is the starter clutch. i went on bike bandit and got the rollers, springs and caps for around 40 bucks including shipping. i...
1-6 of 6 Results
Top