09BlueRebel

Wanted to see if I could easily raise the shift lever (and inch or 2) so that I wouldnt have to bend my foot 45 degrees towards the ground to get under it to upshift!

Any help and pointers would be appreciated.

__________________

shadetree

Remove the 10mm. bolt that clamps it together, pull it off and locate it in the desired position, reinstall the bolt. Easy enough?

__________________

Twister

I would add: Do not over-tighten, use a. tiny drop of lockite blue on the threads of the bolt, to keep it from coming loose.

__________________
Every ride is a joyride on a Rebel

1986 CMX250C "Miss Triplehorn" 17K miles
1984 GL1200A 106K miles

09BlueRebel

thank you guys yet again!

__________________

bB2NER

If you loosen both 10mm nuts the shift rod can be turned to adjust shifter height. One has right hand threads and the other left.
If you remove the rear arm to adjust you will likely mess up the arm geometry.

__________________
Current Rides: Drive less Ride more!!!
09' Rebel 250 Bobber (General Lee Tribute)
86' Rebel 250 Limited (black/gold)
79' Hawk CB400T (black)
92' Shadow 1100C (red/silver panels and frame)

Jim Henderson

folks,
I've got the exact same problem except it is with my 450 is the fix the same?
As always thanks for the help.
Jim

__________________