Carb Rebuild Kit (Where to get one?)

[Tin Man]

Can anyone recommend any good places online to get a rebuild kit for my '86 cmx250 c. I have done a few searches, and just got the run around. I got the bike running with a seriouse cleanout, but it still has to have the choke partially on to run, and the fuel/air mix screw is in all the way. Any suggestions are greatly appreciated.

[Big_J]

I got the last one I use from bikebandit, you can get there by clicking the ad on the top right of the site, if they are out you can try ebay, i used to see them there from time to time.

[Tin Man]

Thank you very much. I'll give them a try.

[trouble shooter]

Can anyone recommend any good places online to get a rebuild kit for my '86 cmx250 c. I have done a few searches, and just got the run around. I got the bike running with a seriouse cleanout, but it still has to have the choke partially on to run, and the fuel/air mix screw is in all the way. Any suggestions are greatly appreciated.
just a little bit of info that i hope will help you out, 99% of the time you dont need a rebuild kit because most of the parts in the kit have no effect on the symptoms you describe. Your most likely problem, even though you say you cleaned the carbs is the idle jets which have up to 24 small needle holes each. Somtimes these can be so bad especially if the bike has been sitting a long time that these must be replaced. I suggest you either replace these or get yourself some fine sewing needles and clean all the holes before spending any money on parts you dont need.